Klippel optimization has been used in the design of Hydrogen SPL elements. In the 10-hour testing, the behavior of the element is studied with numerous measurement results, and thus the weak points and problems that require improvement are found already in the early design phase. The element is fired with up to four times the power compared to its power duration. The end result is an element with a very even impedance response, i.e. it receives power well at all frequencies, has good sensitivity and withstands power properly.
If you want to play LOUD, the Hydrogen SPL is an excellent choice as an element. These elements have 2x1 ohm voice coils, but their impedance behavior is so smooth that you can use them with Ground Zero's mono amplifiers connected to a nominal load of 0.5 ohms! A solid and well-breathable cast frame holds the element together and allows the subwoofer to breathe properly through the frame. Functional voice coil ventilation and sufficiently robust voice coil keep the operating temperature of the coil correct even during heavy use. The double lower suspension controls the movement of the cone and the fastening of the upper suspension and the cone, which is secured by stitching, can withstand even a more violent trajectory. Model
High-Quality SPL subwoofer
Power Handling (RMS/SPL.)
1500 / 3500 Watts
Impedance
2x 1 Ohms
Efficiency
87 dB
Power Recommendation
1500 – 3500 Watts
Voice Coil
75 mm / 3″ Copper
Membrane Layout
Reinforced paper
Max. Excursion (Xmax)
45mm / 1.77″
Mounting Ø
360mm / 14.17″
Resonance Frequency (Fs)
36.3 Hz
Overall Qaulity (Qts)
0.52
Equiv. Air Volume (Left)
32.8 L / 1.16 cu.ft..