Easy-to-use, magnetically attached led lights for trailers. The wireless led lights are rechargeable and they work for about 10 hours on a single charge. It is possible to charge the battery via a USB connection, with mains power or from a cigarette lighter plug.
The lights attached with magnets can be easily removed and it is possible to use them in different trailers. The 7-pin light plug acts as a transmitter. The lights have four functions: rear lights, turn signal, brake light and license plate light
The wireless light set includes two led taillights, a 7-pin light plug, a USB charging cable and charging adapters for mains power and a cigarette lighter plug. The products are packed in a metal storage box.
- Voltage: 12/24 V
- 7-pin plug
- 4 functions: rear lights, turn signal, brake light and license plate light
- Carrying capacity: 30 m
- Battery: lithium battery 3.7 V / 2220 mAh
- Operating time: about 10 h
- Charging time: 3 h
- Operating frequency: 2.4 GHz
- Operating temperature: -40 °C to +65 °C
- Protection class: IP67
- Road traffic approved (EMC, ECE, R10)
Pairing the lights to working order- Remove the cover on the end of the transmitter.
- Connect the transmitter to the 7-pin plug and turn on the vehicle's lights.
- Within five seconds, insert the supplied wooden stick into the small round hole at the top of the transmitter and press the code switch.
- Switch on the light currents, NOTE! The batteries of the wireless lights must be fully charged.
- Within five seconds, insert the supplied wooden stick into the small round hole at the top of the transmitter and press the code switch. The transmitter and light signals meet within 5 seconds. If the operation is successful, the light turns on. If not, repeat this procedure again.
- Repeat the steps with the other light (points 3-5).
- Put the transmitter cover back in place. Now the light kit is ready for use.
