A dent removal kit that allows you to remove dents from your car’s bodywork without damaging the paintwork. With this kit, you can remove dents caused by minor collisions or hailstorms from the bodywork, excluding the edges and corners.
Contents of the pack:- 1 x glue gun
- 1 x pull-out tool holder
- 1 x rubber mallet
- 7 x pull-out tools
- 1 x levelling pen
- 1 x glue stick
- 1 x plastic scraper
- 1 x knurled nut
- 1 x cleaning cloth
- 1 x glue removal wipes
- 1 x user manual
Instructions for use:- Insert the glue stick into the glue gun and plug the glue gun into the mains. Allow it to warm up for 10–15 minutes before use.
- Clean the area around the dent with a cleaning cloth and apply hot glue to the centre of the dent.
- Select a pull-out tool suitable for the dent and attach it to the hot glue.
- Fit the pull-out tool holder onto the tool and adjust it to the desired height. Tighten the knurled nut and turn it until the dent has been pulled out. Stop turning the nut when the dent is level with the car body.
- Put on protective gloves and cover the excess adhesive with towels for 10–20 seconds to allow the liquid to penetrate the adhesive, then wipe it away.
- If you have applied too much adhesive to the surface, you can remove it by tapping it with a scraper and a rubber mallet.
- If the dent is large, repeat the process.
Safety instructions:- Wear safety goggles and sturdy work gloves during use.
- Contains adhesive: keep out of reach of children. This product is not a toy. Do not allow children to play with it or near it.
- Use only as intended in these instructions.
- Check before each use; do not use if any parts are loose.
- Keep the product labels and nameplates, which provide important safety and technical information about the product.
