- SteyrTek Adapter (circulation piece)
- Thickness: 1 inch = 25.4 mm
- Bolt distribution: 4x108/4x100
- Center hole inside 65.1 mm
- External dimension of the collar on the outside (substitute for the shaft)54.1
- Outer diameter 160 mm
- 1 pc in the package
If you want to ensure that the adapter is centered in relation to the car, use an adapter. Choose an adapter where the outer diameter is the inner diameter of this adapter, i.e. 65.1, and the inner diameter is the thickness of your car's axle.
With this you change the bolt distribution in a car with 4x108 distribution to match 4x100 distribution. At the same time, you bring the rim 25 mm outwards, i.e. reduce the ET. As shown in the picture, the stud bolts and nuts (12 mm x 1.5 pitch) with which the rim is attached to the spacer are included in the delivery. The bolts for attaching the spacer to the hub of the car are not included in the shipment. Use car bolts. In a thin spacer, you may have to lower the head of the bolt or get bolts with a lower base.
Top class aluminum from SteyrTek.
Show or racing use only, not approved for road use.
