If your player does not have RCA outputs for connecting an amplifier, you can still connect the amplifier using high-quality AAC, which changes the speaker outputs to line level.
Features:
- Compatible with Start & Stop cars
- Ingenious speaker-level input with ADEP circuit (Advanced Diagnostics Error Protection)
- Maximum supply voltage at speaker-level input 14V
- Splitter filters can also be used with fully active front speakers thanks to extensive adjustment possibilities.
ADEP - Intelligent speaker-level input In the new generation of factory-installed car radios, the speakers are also connected to the car's diagnostics, thus terminals with a normal speaker-level input immediately give a fault code to the car, the ADEP protection developed by Audiotec-Fischer does not cause a fault code in these cars.
Start & Stop The new type of regulated power source developed by Audiotec-Fischer in the G series enables 100% operation even in Start & Stop cars, i.e. the amplifier stays on, even if the voltage sometimes drops to around 6 volts. This also causes no damage to the amplifier itself thanks to intelligent regulation.
- Maximum input voltage to speaker inputs: 16 Vrms (= 65 W / 4 Ohm)
- Maximum level of line output: 4 V
- Frequency response: 18 Hz to 80000 Hz
- Input impedance: 13 Ohm
- Maximum current for remote output: 200 mA
- Dimensions: 77 x 37 x 20 mm
