Klippel optimization has been used in the design of Hydrogen SPL elements. In the 10-hour testing, the behavior of the element is studied with numerous measurement results, and thus the weak points and problems that require improvement are found already in the early design phase. The element is fired with up to four times the power compared to its power duration. The end result is an element with a very even impedance response, i.e. it receives power well at all frequencies, has good sensitivity and withstands power properly.
If you want to play LOUD, the Hydrogen SPL is an excellent choice as an element. These elements have 2x1 ohm voice coils, but their impedance behavior is so smooth that you can use them with Ground Zero's mono amplifiers connected to a nominal load of 0.5 ohms! A solid and well-breathable cast frame holds the element together and allows the subwoofer to breathe properly through the frame. Functional voice coil ventilation and sufficiently robust voice coil keep the operating temperature of the coil correct even during heavy use. The double lower suspension controls the movement of the cone and the fastening of the upper suspension and the cone, which is secured by stitching, can withstand even a more violent trajectory. 8″ subwoofer
2x1 ohm voice coils
2.5″ copper voice coil
Mounting diameter 187 mm
Mounting depth 145 mm
Aluminum cast basket
Klippel optimized triple magnets
Cone Reinforced paper
Power Handling 700 W RMS, 1500 W SPL Power
Sensitivity 80 dB
Xmax 40 mm
Fs 38.3 Hz
Qts 0.381
Left 4.77 L.
