DROPPER - SAFE AND EASY SNOW FALLING
The Dropper snow thrower is a convenient and safe tool for dropping snow from the roof of houses, stables, warehouses, etc. You can use the Dropper from the ground or from the ceiling. The Dropper snow thrower is made of aircraft aluminum and thus withstands hard use. The blade part of the dropper is thin and graceful, which pushes into the snow cover on the roof. When the blade has pushed enough into the snow cover, it breaks under its own weight and starts to slide quickly down the roof along the Dropper's sliding plastic. The handle of the dropper has a separate splitting blade that splits the sliding snow into a boulder and thus it does not come into the hands of the user. The Dropper snow thrower consists of a blade part and three stem parts. As an accessory, a special blade is available to facilitate snow removal from the roof. In addition, spare plastics are available as spare parts.
Dropper SNOWTHROWER OPERATION - FROM THE GROUND
Assemble the stem of the Dropper snowdropper and connect it to the blade in such a way that the edge of the blade where the sliding plastic leaves points to the stem. Tighten the parts carefully. Attach the splitting blade to the stem. Start falling snow in small slices if the snow is thick on the roof. Push the blade evenly into the snowpack on the roof. If the blade does not sink into the snow cover, take a smaller slice. First, take a small layer from the entire width of the roof and then repeat it. If the blade sinks into the snowpack well, you can also take larger layers at once.Dropper
USE OF THE SNOWTHROWER - FROM THE ROOF
Assemble the stem of the Dropper snowdropper and turn/connect it to the blade so that the edge of the blade, where the sliding plastic leaves, points away from the stem. Tighten the parts carefully. If you have purchased a long special blade, replace it between the stem and the blade part. Lift the Dropper snowdropper from the ridge to the edge and start pulling the blade from the eaves along the ridge. Make sure the plastic hangs from the eaves towards the ground. First, take a small layer from the entire roof area and repeat the same again. If the blade does not sink into the snow cover, take a smaller slice. If the blade sinks into the snowpack well, you can also take larger layers at once.
Package Contents:
•3x 2 m long stem part, one part has a ponsis
•1x Bracket. Works as a joint for the stem/end blade
•1x Cutting blade, where the plastic and vertical cutters are attached
•1x sliding plastic
•1x Operating and safety instructions
Available accessories:
•Additional pipe 2m
•Sliding plastic Weight: 4.5 kg
