AA97_6N heater D350xL180mm
When choosing a stove grill, the entire surface area of the stove's nest is taken into account, the inner length and inner width of the nest are measured. Can be disposed of as scrap metal.
Aalto-Arina AA97_6N is suitable for the following wood stoves:
Rare M3/M1 4.5–13 m³
Hello Ukkotontu 8-18m³
Narvi 12
Narvi 12 NM Greenline
Narvi 13
Narvi 14
Narvi16
Narvi 18 NM Greenline
Narvi 18NM stainless steel
Narvi 22
Narvi Stony 18 NMO
Viki 15
Aalto-Arina in the stove
Aalto - Arina's effect on the fire incident
In Aalto - Arina, the trees light up very well.
During the formation of ash and coal, the ash rolls away from the air brush. This is facilitated by the brush-like shape of the grate.
Aalto - The ridge shape of the grate is wide at the bottom, so the air flow coming through the grate is compressed before discharging through the grate, thus the air flow speeds up, entering the so-called "turbulence state.
Because of this, Aalto - Arina oxidizes well throughout the duration of a fire incident.
Smoke damper adjustment
The smoke damper is adjusted to a smaller size and plenty of air is given through the ash box to the bottom of the grate, thus the flue gases have more time to bale inside the stove.
If there is no smoke damper, then the flow of flue gases is restricted, either from the end of the chimney. Or ceramic stove stones are placed inside the stove in its horizontal pipe, about ¼ - ½ of the surface area of the pipe.
Wood needs 7-10 m³ of air per 1 kg of wood for combustion (gasification).
Now the fire gases coming out of the wood burn well, so the stove heats up well from all sides, this also saves the stove structure, when the stove heats up all over.
The indoor air in the sauna room also now circulates efficiently through the warm stove, so the sauna heats up faster.
At Aalto - Arina, wood consumption has dropped by 15-30% per heating cycle.
Even the chimney sweeps, as professionals in the field, have noticed the functionality of Aalto - Arina.
The flue gases are significantly cleaner in the flue than in the cast iron grate.
Wood quality:
The trees should be of uniform quality, both in terms of moisture and diameter.
Burning round wood should be avoided, because their moisture percentage may be higher than that of split wood, which affects the burning result.
This way you guarantee that the fire event is even and the heat output is the best possible per kilo of wood.
Ignition:
Before lighting the Aalto - Arina, clean it, take hold of the front part of the grate and shake it sideways, give the so-called "hairy owl", which causes the ash to fall out.
The grate is not lifted out of the nest, but is moved to the side and the ashes are knocked into the ash box.
When you use a kindling piece and a sparkless birch valve in the ignition phase, from which the spark has been removed, the particle emissions are reduced (1/8) to one to one eighth.
When the temperature of the stove has risen high enough, you can also burn birch wood.
Can be disposed of as scrap metal.
UPGRADE YOUR FIREPLACE WITH THE AALTO GRILL
Energy-efficient Aalto-Arina
-woods light up better
- more efficient fire event
-cleaner combustion gases
- wood savings of about 15-30%
